1970 Charger Registry Message Board
August 20, 2017, 11:35:20 PM *
Welcome, Guest. Please login or register.

Login with username, password and session length
News: Welcome to the 1970 Charger Registry Message Board. Visit the 1970 Charger Registry main site at www.1970chargerregistry.com
 
   Home   Help Login Register  
Pages: 1 [2]   Go Down
  Print  
Author Topic: Make your own torsion bar removal tool!  (Read 1842 times)
Plasma Nut
Hall of Fame Member
*****
Offline Offline

Posts: 2542



« Reply #15 on: July 15, 2014, 06:59:26 PM »

   That must have been fun. good thing you didn't get hurt when you cut them.
Logged

70 charger 500, 07 Dodge Ram 1500 quadcab 80 RS Camaro 09 Pontiac G6
    Just another bump in the road of life!  
Dodge Don
Administrator
Hall of Fame Member
*****
Offline Offline

Posts: 3500


The future is unwritten....


WWW
« Reply #16 on: July 15, 2014, 09:25:57 PM »

I used an L shaped trailer hitch, drilled holes in it for u clamps and worked like a charm.
Logged

1970 Dodge Registry You Tube Channel
Kent
Newbie
*
Offline Offline

Posts: 49



« Reply #17 on: June 13, 2017, 11:41:49 AM »

I  know this is a old thread but I was just checking things out and seen this. That being said I thought I'd throw my own version of the torsion bar removal tool into the hat. I could wiggle them slightly  but couldn't pull them out. So I wrapped the bar with a phone book and clamped on a set of 3 jaw welding vise grips and tapped on the grips until she slid out. Just that simple. Cleaned up the bars not a mark on them. Just the black paint and silver paint dabs.  Our phone book here on PEI is only about a inch thick. Not one of your big monsters from a big city.
That is al.
Logged

Kent

70 Charger 500
80 Roadrunner
15 Ram SLT
Pages: 1 [2]   Go Up
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.13 | SMF © 2006-2011, Simple Machines LLC Valid XHTML 1.0! Valid CSS!